![]() ![]() Thread starter 6 strengthrehab 411 302 Texas Thanks all. The video creation process did take a little while, maybe 10-20min. ) This makes your End Frame show/match your actual Numbers of Frames, else you need to increase it by one to get your final Frame Amount. The instructions were straight forward and the trial version had many overlays with the main limitation being you can only publish a 2 minute video. Oh and usually you should set your Start Frame to 1, not 0. It lets you work with footage from GoPro, 360fly, Sony ActionCam, Garmin VIRB, and many other devices. You then need to set your End Frame to approximately the mentioned 4320 and you're fine. RaceRender lets you create sports and racing videos with custom data and graphics overlays, GPS telemetry, multiple camera picture-in-picture, 360 video, etc. Uncheck use_preview_range and then your End Frame in your Timeline should show 250 as well as it is now set to in your Render Properties. ![]() The 9357 are nearly 6:30 mins, so this should be reduced to about 24 frames/sec * 60 sec/min * 3 min = 4320 Frames. Video clips can be connected together, rearranged, and trimmed by using the Input File Join functionality on the Main screen. The 250 Frames are just 10.4 seconds (or 10 Seconds plus 10 Frames, you already stepped one frame backwards in your screenshot to 10+09) which were rendered in your case. Copy the video files to your computers hard drive, and then use those copies with RaceRender. A: Yes, although RaceRender was designed for the purpose of processing concurrent video, audio, and data sources, it also has the capability to work as a sequential video editor. If it's checked, your Timeline Frame Range Settings only effect Playback ( Ctrl+ A), but when you render your Movie ( Ctrl+ F12), the Render Properties Frame Range will be used (both differ in your case 9357/250). You can set your End Frame visually by selecting the last non-black Frame of your footage in the VSE and then hovering your mouse over the Timeline and pressing E for End Frame (as indicated in the Frame menu) or S for Start Frame to set it as your current frame (that's the green vertical line in the VSEs Sequencer View and in the Timeline).īut make sure, as in your case you did this "wrong", that you unselect the " Use an alternative start/end frame range for animation playback and OpenGL renders instead of the Render properties start/end frame range".Īs you can see in your Screenshot, you checked it:
0 Comments
Leave a Reply. |